Wednesday, July 11, 2012

Norco Build Part One

So I've been receiving parts for the new NAS over the past few weeks and I've started the build.
Here's what I've got:
Norco 4224
Norco 4224 120mm fanwall
Asrock Z77 Extreme4-M
Intel i5 3750K
Noctua NH-U9B-SE2 CPU Cooler
2x 16GB EVO Corsa DD3 1333 MHz Kits
Supermicro AOC-USAS2-L8e
Intel RES2SV240 Expander 
Corsair HX-650M Modular
3x Cougar CF-V12HPB Vortex PWM 120mm
2x Noctua NF-R8 PWM 80mm
2x Akasa PWM splitters AK-CB002

I've got more pics and info to come but here's a taster...
24 bays of hot swapping goodness
Nice small power and reset buttons
80mm fanwall, my 120mm fans are mounted
on the other side of the fanwall. It was way
too tight for the molex connectors otherwise.
Backplane showing the 6 SAS connectors
Backplane showing the redundant molex connectors
The 80mm fanwall which I would see replaced
with the 120mm version.
Corsair HX650 modular PSU.
Asrock Z77 Extreme4-M
Stock Intel cooler for the i5 3750K,
the profile is pretty low these days!
GEIL EVO Corsa 16GB RAM Kit
32GB's in full glory
Closer look how the 80mm fanwall is setup.
The fans are able to slide out and are connected in serial.
While these push a fair amount of air they are very loud
and the supplied 3 pin to molex connector doesn't help!
Supermicro AOC-USAS2-L8e PCI-e x4 2.0
The backing plate is actually mounted backwards
however I had no issues just removing it and
sitting it in the slot.
Intel RES2SV240 Expander, the molex connecter feels
like it could come off the board with too many disconnect/reconnects.
Low profile adapter if you need it plus you also get
6x 8087 to 8087 SAS cables (2 of these are only small
probably with the assumption you will be connecting
to a hba nearby). 
Fanwall?... kind of...
Noctua NF-R8 PWM 80mm, comes well packaged with low and ultra low noise adapters.
Cougar CF-V12HPB Vortex PWM 120mm, not as generous as the Noctua in terms of accessories.
Noctua NH-U9B-SE2 CPU Cooler, the beast with 2 92mm non-PWM fans. Intel and AMD mounting kits included.
Almost makes me want to install a perspex window...
CPU, fan and RAM installed...
I attempted briefly to remove the RAM heatsinks
however they seem glued in place and I felt I would snap
them so I moved the fan up slightly. Not the best look but it
still performs great!

No comments:

Post a Comment